Cutting plotter is a computer and connected to accept the computer's instructions, driven by computer-controlled equipment, ad decoration industry in the use of a very common device. The following, for you to talk about cutting plotter connected to the power cable requirements and precautions.
First of all, to ensure that the cutting plotter power switch in the off position, and then one end of the power cord into the plotter's power outlet, the other end connected to the power outlet. Do not work, first turn off the power, then the power plug out from the outlet, should not plug in power when the power plug.
After the cutting plotter shuts down, the time interval for starting the machine again should not be less than 30 seconds. Pull the power plug, the force can not be too fierce, so as not to damage the connector. Connect the serial, parallel cables to ensure that the cutting plotter power supply, the computer power is off.
Connect one end of the parallel cable (pin plug) to the computer parallel socket and use the manual locking screw on the plug to lock the plug on the socket; the other end is connected to the parallel socket of the cutting plotter and use the parallel socket On the wire buckle will plug tightly with the socket.
Connect one end of the serial cable (pin plug) to the computer serial socket and the other end to the serial socket of the cutting plotter. Use the manual locking screw on the plug to lock the plugs at both ends of the cable to the socket on.