First, that both should all electrical type. As far as I know, there are a lot of people always put CNC engraving machine and laser engraving machine is a misunderstanding of what, in fact, the two are very different, and with the development of the times, this difference is also growing obviously, with the laser technology continues to mature, more and more obvious advantages over traditional computer sculpture, mainly from the following aspects lattice engraving, vector cutting, engraving speed, carving intensity, spot size, engraving materials to compare the two different.

1: Engraving Strength: Carving strength refers to the strength of the material onto the surface of the laser. For a particular engraving speed, the greater the intensity, cutting or carving the greater depth. You can adjust the intensity of the use of engraving machine panel may also make use of the computer to adjust the print driver. In the range of 1% to 100%, the adjustment is 1%. The greater the intensity, the greater the equivalent speed. Depth of cut more deeply

2: Engraving speed: it is the difference between first CNC engraving machine and laser engraving machine engraving speed, engraving speed refers to the speed of the laser head movement, usually IPS (inches / sec) that bring high-speed production efficiency. Speed is also used to control the cutting depth, for a given laser intensity, the slower the speed, cutting or carving the greater depth. You can use the panel to adjust the speed engraving machine, can also use the computer's printer driver to adjust. In the range of 1% to 100%, the adjustment is 1%. Hummer machine advanced motion control system allows you to carve at high speed and still get quality carving hyperfine

3: spot size: in fact, CNC engraving machine and laser engraving machine spot size is different, the laser beam spot size may utilize different focal length lenses can be adjusted. Small spot lens for high-resolution engraving. Engraving large spot lens for the lower resolution, but Vector cutting, it is the best option. Standard configuration of new equipment is 2.0-inch lens. Its spot size in the middle, for a variety of occasions.

4: Lattice sculpture: carved lattice resembles high-resolution dot matrix printing. Laser head from side to side, each carving out a series of points of a line, and then the laser head moves up and down while carving out a number of lines, and finally constitute a full-page image or text. Graphics, text and vector graphics can be used to scan the dot engraving.

5: Vector Cutting: engraving with different lattice vector graphic cut in the outer contour line for. We usually use this model in the timber, Senanayake tablets, paper and other materials through the cut, it can operate in a variety of marking material surface.

6: Can carving materials: wood, glass, metal plates, glass, stone, crystal, Corian, paper, color plates, aluminum, leather, resin, spray metal