As far as I know, there are a lot of people always put CNC engraving machine and laser engraving machine misinterpreted as something else, in fact, the two are very different, and with the development of the times, the differences are more Clearly, as laser technology continues to mature, more and more obvious advantages over traditional computer carving, the following main terms of lattice engraving, vector cutting, engraving speed, carving intensity, spot size, engraving materials to compare the two different.

1: Engraving speed: First of all the differences of CNC engraving machine and laser engraving machine engraving speed, engraving speed refers to the speed of the laser head movement, usually IPS (inches / sec) that bring high-speed productivity. Speed ​​is also used for controlling the cutting depth, for a given laser intensity, the slower the speed, the depth of cutting or carving the greater. You can use the engraving machine panel to adjust the speed of the computer can also use the print driver to adjust. In the range of 1% to 100%, 1% adjustment. Hummer machine advanced motion control system can make your high-speed carving, still get ultra-fine quality of the carving

2: Sculptures Strength: Carving strength refers to the strength of the material onto the surface of the laser. For a particular engraving speed, intensity, the greater the depth of cutting or carving the greater. You can adjust the intensity of use of the engraving machine panel, also use the computer's printer driver to adjust. In the range of 1% to 100%, 1% adjustment. The greater the intensity, the equivalent of the greater speed. Depth of cut more deeply

3: Lattice sculpture: carved lattice resembles high-resolution dot matrix printing. Laser head from side to side, each carving out a series of points of a line, then the laser head moves up and down while carving out a number of lines, and finally constitute a full-page image or text. Graphics, text and vector graphics can be used to scan a dot engraving.

4: Spot size: Actually CNC engraving machine and laser engraving machine spot size is different, the laser beam spot size can take advantage of different focal length lens can be adjusted. Small spot lens for high-resolution engraving. Carving large spot lens for lower resolution, but for vector cutting, it is the best option. Standard configuration of the new device is 2.0-inch lens. Its spot size in the middle, for a variety of occasions.

5: Can carving materials: wood, glass, metal plates, glass, stone, crystal, Corian, paper, color plates, aluminum, leather, resin, spray metal

6: Vector Cutting: With dot matrix engraving, vector cutting outer contour in the graphic line for. We usually use this model in wood, Senanayake tablets, paper and other materials through the cut, it can operate in a variety of marking material surface.