There are two main engraving machine control, a control method is now widely used computer, and the other one is the DSP handle control. The latter is now used relatively small, but in some customer groups used in woodworking engraving machine and partly customers accustomed to using the handle control, believing it more convenient. But customers are not familiar with the control handle, and today we engraving machine manufacturers to install wood engraving machine DSP handle control program introduction.
Before installing the driver handle, turn the CD-ROM in the "DSP Operating System" folder Kaoru D computer disk, and then randomly assigned the USB cable to connect the computer and the DSP handles. The system will prompt "Found new hardware" and the pop-up "Found New Hardware Wizard" window, click and select "No, not this time" and click "Next", click and select "from a list or specific location installation (Advanced) "and click" Next ", select" include this location "and then click on the edge of the" Browse in the search ", found just copied to the D disk folder under the" handle USB drive "and click" OK "to return; then click" Next "and click again" Next "until" Finish ", click on it to end the entire USB controller driver installation process.
In the case of this driver is not installed or connected to the handle, if started directly download the application, "ZHBUSBConnect", the system will prompt "No open lower machine or connect the USB interface" and click "OK", and prompt "create empty documents fail. "
Under convinced that there is no misuse, and USB connection under normal circumstances, if it is still prompts the above error message, check the following steps: (for XP) in the WINDOWS desktop, right-click "My Computer" and click "properties ", click the" Hardware "and click the" Device Manager "in the pop-up window of the device" "There will be an item with a yellow" Universal Serial Bus controllers! "the USBCAM item appears, right-click it , and then click "Update Driver", after the operation ibid.; such as not enough, then please change a USB port or use U disk to test port can usually find the problem.
Note: ① here, because the handle is controlled by the computer, the computer is its relative level should be lower, so the next crew actually refers to the USB controller, PC refers installed in the computer to download the program.
② After reinstalling the WINDOWS operating system, drivers handle this basis having to reinstall the above steps again.