For engraving machine maintenance, research experts have a few ideas: Note schedule to clean and lubricate machine parts, engraving machines in use, there will be quite a lot of dust and impurities to enter, resulting in a large screw drive bearing resistance. The key to our need for relevant parts engraving machine lubrication:
(A) lubricating parts: X, Y, Z-axis screw, light pole.
(2) lubricating composition: a mixture of oil and butter, and easy too thick.
(3) lubrication cycle: as the working environment and working time machine to set, usually after a day off work to clean out debris. Monthly various parts of the fuel, high-speed idling lubrication.
(4) lubrication: lubrication during triaxial available within six anti hexagonal wrench screw coupling between the motor shaft and tighten the screw head on, to prevent part of the three-axis due to mechanical loosening caused by dislocation.
(5) Lubrication steps: pre-lubricated first screw, nut and bearing rails above the impurities removal, if removal can not afford to be used gasoline to clean, and then gradually increase after the injection of the lubricant were idling speed, that is not put the plate, three-axis adjust.
