Mold engraving machine , there are many problems in use, you want to know where is the problem , or need an experienced , long-term exploration out . When installed, the factory supplied with the test drawing mold engraving machine engraving tests, such as the completion of the test accurately engraving , delivery and acceptance testing is completed . If intact, and then configure the control contract with random accessories imitation single inventory with random machine .

That mold engraving opportunity at work what the problem yet. For example , carved or engraved not deep shades . That is what causes ? Then you think about some of the usual usage and attention. Check the mold engraving machine water system flow is smooth, bent pipes or water pipes may burst ; checking whether the normal focal length , you may need to recalibrate ; whether checking optical path normal , you may need a new calibration ; examination paper plates spread is too thick, water is excessive re corrections ; checking whether the beam is parallel to both sides of the belt may be sent , you need to adjust the belt ; checking lens is broken, if broken, need to be replaced ; checking lenses or laser tube transmitter is contaminated with , we must re-cleaning . Etc. Such problems are found in the work, and then follow these problems in one go exclusion , make sure that they work smoothly .