1, the laser cutting machine carried to the specified location, as close to the back of the machine there is an electrical plug there, tear packaging film, and then the chassis cover open gracefully machine.

2, installed fans: We took the fan, and went behind the machine, pull out the machine under the gray flexible duct, the flexible duct buckle on the blower, and lock with a screwdriver, locking the fan will plug into the laser to the cutting unit flapper.

3, installed pump: the white tube is inserted in the pump (Note: To insert a little tight, so as not to start work when the air pump trachea was shake off), and then plug in the pump laser cutting machine body flapper can.

4, installed chiller: box of ingredients to come up with two white pipe, one end of the two pipes are inserted in the inlet and outlet ends of the chiller, then the other end of the pipe inserted in the corresponding laser cutting machine into the above and outlet locations. That inlet to inlet, outlet to outlet, then plug in the power cord chiller laser cutting machine body flapper.

5, the CO2 laser tube: first turn the machine back cover, then CO2 laser tube is removed from the tray (Note: Take the laser tube must pay attention to gently, so as not to break up), put the laser tube on time, there will be an end of the copper head light mouth against the first surface mirror, mirror 5-10cm from the first position away, and then a short white pipes connected to the outlet end of the copper head, long White pipes are connected to the left side of the glass inlet. Then thick high-voltage power lines and the other coarse pick up, and wrapped with plastic insulation is good, a thin line and the other negative negative thin line pick up, the same plastic insulation wrapped around good, back cover, and lock.

6, power: the ingredients of two black box inside the power cord plugged into the left side of the fuselage behind the laser cutting machine jack plug on the other end before the quasi-good flapper, flapper power can be.

7, boot: Go right side of laser cutting machine, open the first rocker switch (ie, control board switch), the machine enters the reset state; open the second switch (ie, laser power switch); open the third switch (ie pump fan switch). If Double laser cutting machine, just a switch is a control board switch, the second switch is a switch laser power, laser power three switches are two switches, four are fan, air pump switch