Finishing line parallel cut surface finish using the most widely used, especially for more complex surfaces, but not too steep surface occasions.
Contour passes mainly used for processing more complex curved sidewalls steeper occasions. Since the processing in the process contour height remains unchanged, the phenomenon does not occur knife bar, and can greatly improve the stability of the machine, to improve the quality of the workpiece.
Radial radiation is mainly applied to finishing top view similar to processing round, round ring model, fan-shaped distribution path.
Flowline is mainly used for finishing small number of surface, surface relatively simple occasions. Processing tool movement along the surface of the flow line, movement more stable, moderate path spacing density, high surface quality of machined parts. When connected to more than one surface boundary can be joined together along the surface of the flow line processing. When the surface is small, while large, is not appropriate processing Flowline. Because at this time the faces were likely to be processed, the path towards more confusion.
Surround equidistant tool path ways to generate tool paths surround-like. According to the characteristics of the path surround, surround equidistant Z can also be subdivided into equidistant to the projector, curved shape contour, surface appearance, three different isometric isometric effect. These methods are used in different occasions, the system mainly uses the Z direction equidistant projection method. Isometric passes from the space surrounding the method of generating the same path for both carved flat position but also the position of the steep surface shape