When we needed some stone carving MDF will be used when the computer engraving machine, computer engraving machine and therefore the scope of application is quite extensive. Is not important if you do not pay attention in the course of its maintenance, will make the machine failure, affecting the normal use of the function. So in order not to affect the use of functional computer engraving machine, its care and maintenance is vital.
First, the user should regularly defragment it, and optimize your computer system. The system regularly killing the virus, but remember to work when the antivirus program can not be opened, because when this work is very susceptible to interference.
Secondly, after the engraving work done, in order to be able to facilitate the next work must pay attention countertop neat and clean. Pay attention to regularly clean up some of the material scrap rail, this can prevent debris from causing interference engraving machine card machine phenomenon.
Then, above the chassis must remember to regularly clean the dust, so to ensure good heat dissipation, and can well prevent abnormal IPC card error. Computer engraving machine when not in use, in the case of relatively low temperature of the water in the tank is best drained to prevent the cracking phenomenon.
Finally, to regularly check the standards applicable to increase the temperature of the oil. At least to ensure that the lowest temperature. Screw must be cleaned regularly to prevent any stolen Nianshang Qu.
As long as we said above points do maintenance work, then you can very well reduce the frequency of faulty computer engraving machine, engraving machine and can guarantee the life, while more favorable for us.